Pro-Link Lithofin MN Slate Oil 120050 - Manual (Page 3)

Material Safety Data Sheet
Printed: 20.07.2005
Revised: 20.07.2005
Lithofin MN Slate Oil
3
Storage
Requirements to be met by storerooms and receptacles:
Store receptacles tightly closed at a cool and dry place with sufficient ventilation
Prevent any seepage into the ground.
Information about storage in one common storage facility:
Store away from foodstuffs.
Store away from feed.
Further information about storage conditions: None.
Storage class 3A Flammable liquid
—————————————————————————————————————————————
8 Exposure controls and personal protection
Additional information about design of technical systems:
No further data; see item 7.
Components with limit values that require monitoring at the workplace:
The product does not contain any relevant quantities of materials with critical values that have to be
monitored at the workplace.
Additional information:
The lists that were valid during the creation were used as basis.
Personal protective equipment
General protective and hygienic measures
Keep away from foodstuffs, beverages and feed.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
Do not inhale dust / smoke / mist.
Do not eat or drink while working.
Use skin protection cream for skin protection.
The usual protective measures based on the application have to be followed.
All protective equipment used shall be according to 29 CFR.1910 Subpart I Personal Protective
Equipment
Breathing equipment:
Not necessary if room is well-ventilated.
Short term filter device:
Filter A
A respiratory protection program that meets OSHA's 29 CFR 1910.134 and
ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace
conditions warrant a respirator's use. Always use a NIOSH or European Standard EN 149 approved
respirator when necessary.
Protection of hands:
Wear chemically resistant protective gloves (tested according to DIN EN 374)
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation. Selection of the glove material on consideration of the penetration times, rates of diffusion
and the degradation. After use of gloves apply skin-cleaning agents and skin cosmetics.
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer.
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has
to be observed.
Eye protection: Chemical safety goggles
Body protection: Protective work clothing.
—————————————————————————————————————————————
9 Physical and chemical properties:
General Information
Form: Liquid
Color: Colorless, Clear