Pro-Link Lithofin MN Polish Cream 120049 - Manual (Page 3)

Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin MN Polish Cream
3
—————————————————————————————————————————————
8 Exposure controls and personal protection
Additional information about design of technical systems:
No further data; see item 7.
Components with limit values that require monitoring at the workplace:
8002-74-2 paraffin waxes and hydrocarbon waxes
REL: 2 mg/m³
TLV: short-term value: 2 ppm
Additional information:
The lists that were valid during the creation were used as basis.
Personal protective equipment
General protective and hygienic measures
Keep away from foodstuffs, beverages and feed.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
Do not inhale gases / fumes / aerosols.
Do not eat or drink while working.
Use skin protection cream for skin protection.
The usual protective measures based on the application have to be followed.
All protective equipment used shall be according to 29 CFR.1910 Subpart I Personal Protective
Equipment
Breathing equipment:
Not necessary if room is well-ventilated.
Short term filter device:
Filter A
A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements
or European Standard EN 149 must be followed whenever workplace conditions warrant a respirator's
use.
Always use a NIOSH or European Standard EN 149 approved respirator when necessary.
Protection of hands:
Wear chemically resistant protective gloves (tested according to DIN EN 374)
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
After use of gloves apply skin-cleaning agents and skin cosmetics.
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer.
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has
to be observed.
Eye protection: Chemical safety goggles
Body protection: Protective work clothing.
—————————————————————————————————————————————
9 Physical and chemical properties:
General Information
Form: Pasty
Color: Whitish
Odor: Aromatic
Value/Range Unit Method
Change in condition
Melting point/Melting range:
undetermined
Boiling point/Boiling range: > 130 ° C