Pro-Link Lithofin MN Builders Clean 120035 - Manual (Page 3)

Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin MN Builders’ Clean
3
Information about protection against explosions and fires:
No special measures required.
Storage
Requirements to be met by storerooms and receptacles:
Store receptacles tightly closed at a cool and dry place with sufficient ventilation
Provide acid-resistant floor.
Information about storage in one common storage facility:
Store away from foodstuffs.
Store away from feed.
Do not store together with alkalis (caustic solutions).
Store away from metals.
Further information about storage conditions:
Keep receptacle tightly sealed.
Storage class 8 Corrosive products (VCI)
—————————————————————————————————————————————
8 Exposure controls and personal protection
Additional information about design of technical systems:
No further data; see item 7.
Components with limit values that require monitoring at the workplace:
7664-38-2 phosphoric acid
PEL:
1 mg/m³
REL: short-term value: 3 mg/m³
long-term value: 1 mg/m³
TLV: short-term value: 3 mg/m³
long-term value: 1 mg/m³
7647-01-0 hydrogen chloride
PEL: short-term value: C 7 mg/m³, C 5 ppm
REL: short-term value: C 7 mg/m³, C 5 ppm
TLV: short-term value: C 2.98 mg/m³, C 2 ppm
Additional information:
The lists that were valid during the creation were used as basis.
Personal protective equipment
General protective and hygienic measures
Keep away from foodstuffs, beverages and feed.
Do not eat or drink while working.
Immediately remove all soiled and contaminated clothing
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
The usual protective measures based on the application have to be followed.
All protective equipment used shall be according to 29 CFR.1910 Subpart I Personal Protective
Equipment
Breathing equipment:
Not necessary if room is well-ventilated.
Use suitable respiratory protective device only when aerosol or mist is formed.
NIOSH/MSHA-approved respirator
Protection of hands:
Acid resistant gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
After use of gloves apply skin-cleaning agents and skin cosmetics.
Material of gloves
Polychloropren rubber (CR)
Butyl rubber, BR