Lithofin kf mildew-away – Pro-Link Lithofin KF Mildew-Away 120015 User Manual
Page 3

Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin KF Mildew-Away
3
Information about storage in one common storage facility:
Store away from foodstuffs.
Store away from feed.
Do not store together with acids.
Store away from reducing agents.
Further information about storage conditions:
Keep receptacle tightly sealed.
—————————————————————————————————————————————
8 Exposure controls and personal protection
Additional information about design of technical systems:
No further data; see item 7.
Components with limit values that require monitoring at the workplace:
The product does not contain any relevant quantities of materials with critical values that have to be
monitored at the workplace.
Additional information:
The lists that were valid during the creation were used as basis.
Personal protective equipment
General protective and hygienic measures
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
The usual protective measures based on the application have to be followed.
All protective equipment used shall be according to 29 CFR.1910 Subpart I Personal Protective
Equipment
Breathing equipment:
Not necessary if room is well-ventilated.
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer
exposure use respiratory protective device that is independent of circulating air.
Short term filter device:
Filter B.
NIOSH/MSHA-approved respirator
Protection of hands:
Alkali-resistant gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
After use of gloves apply skin-cleaning agents and skin cosmetics.
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer.
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has
to be observed.
Eye protection:
Tightly sealed goggles
As described by OSHA's eye and face protection regulations in 29 CFR 1910.133
Body protection: Alkali-resistant protective clothing