Pro-Link Lithofin FZ Stain-Stop Water Based 120028 - Manual (Page 3)

Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin FZ Stain-Stop >W<
3
107-21-1 ethane-1,2-diol
TLV:
short-term value: C 100 mg/m³
(H)
Additional information:
The lists that were valid during the creation were used as basis.
Personal protective equipment
General protective and hygienic measures
The usual protective measures based on the application have to be followed.
Avoid contact with the eyes and skin.
Do not eat or drink while working.
All protective equipment used shall be according to 29 CFR.1910 Subpart I Personal Protective
Equipment
Breathing equipment: Not necessary if room is well-ventilated.
Protection of hands:
Chemical resistant gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Check protective gloves prior to each use for their proper condition.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer.
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has
to be observed.
Eye protection: Safety glasses
Body protection: Protective work clothing.
—————————————————————————————————————————————
9 Physical and chemical properties:
General Information
Form: Liquid
Color: Yellowish
Odor: Product specific
Value/Range Unit Method
Change in condition
Melting point/Melting range:
undetermined
Boiling point/Boiling range: > 80 ° C
Flash point:
> 21 ° C Does not support combustion.
Auto igniting:
Product is not self igniting.
Danger of explosion:
Product does not present an explosion hazard.
Density:
at 20 ° C ~ 1 g/cm³
Solubility in / Miscibility with Water: Miscible
pH-value:
at 20 ° C ~ 3-6
Additional information
VOC-Content: 100,1
—————————————————————————————————————————————
10 Stability and reactivity
Thermal decomposition / conditions to be avoided: