Pro-Link Lithofin BERO Rust Remover and Stone Cleaner 120009 - Manual (Page 3)

Material Safety Data Sheet
Printed: 08.11.2004
Revised: 03.11.2004
Lithofin BERO
3
Further information about storage conditions:
Keep receptacle tightly sealed.
Storage class 8 Corrosive products (VCI)
—————————————————————————————————————————————
8 Exposure controls and personal protection
Additional information about design of technical systems:
No further data; see item 7.
Components with limit values that require monitoring at the workplace:
7664-38-2 phosphoric acid
PEL: 1 mg/m³
REL: short-term value: 3 mg/m³
long-term value: 1 mg/m³
TLV: short-term value: 3 mg/m³
long-term value: 1 mg/m³
Additional information:
The lists that were valid during the creation were used as basis.
Personal protective equipment
General protective and hygienic measures
Keep away from foodstuffs, beverages and feed.
Do not eat or drink while working.
Immediately remove all soiled and contaminated clothing
Wash hands before breaks and at the end of work.
Avoid contact with eyes and skin absolutely.
The usual protective measures based on the application have to be followed.
All protective equipment used shall be according to 29 CFR.1910 Subpart I Personal Protective
Equipment
Breathing equipment:
Not necessary if room is well-ventilated.
Use suitable respiratory protective device only when aerosol or mist is formed.
NIOSH/MSHA-approved respirator
Protection of hands:
Acid resistant gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the
preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
After use of gloves apply skin-cleaning agents and skin cosmetics.
Material of gloves
Polychloropren rubber (CR)
Butyl rubber, BR
Nitrile rubber, NBR
Natural rubber, NR
Fluorocarbon rubber (FKM)
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer.
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has
to be observed.
Eye protection:
Tightly sealed goggles.
If splashing of the product is possible wear full face protection. as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133
Body protection: Acid resistant protective clothing
—————————————————————————————————————————————