Pro-Link Optimum Foaming Antimicrobial Soap MH220 EN - Manual (Page 2)

FOAMING ANTIMICROBIAL SOAP #MH250, #MH220, #PM102 Page 2 of 2
Document#: 5500501
5. FIRE FIGHTING MEASURES:
NFPA: Health 1 Fire 0 Reactivity 0
Flashpoint °F/°C (PMCC method): Not applicable
Unusual Fire and Explosion Hazards: None known.
Special Fire Fighting Procedures:
None known.
Extinguishing Media: X Water Fog X Alcohol Foam X CO
2
X Dry Chemical Other
6.
ACCIDENTAL RELEASE MEASURES:
No special requirements. Water clean up and rinse. CAUTION – WILL CAUSE SLIPPERY SURFACES.
7.
HANDLING AND STORAGE:
Store at normal room temperature away from reach of small children. Keep containers sealed. Use older
containers first. Avoid freezing conditions.
8.
EXPOSURE CONTROLS/PERSONAL PROTECTION:
Eye Protection: None required under normal conditions.
Skin Protection: None required under normal conditions.
Respiratory Protection: None required under normal conditions.
Ventilation: None required under normal conditions.
Protective Equipment or Clothing: None required under normal conditions.
9. PHYSICAL AND CHEMICAL PROPERTIES:
Appearance and Odor Clear peach to amber or brown liquid with fruity fragrance
pH (undiluted): 4.5 – 8.5
VOC , %: <5
10. STABILITY AND REACTIVITY:
Stable/Non reactive product.
11. TOXICOLOGICAL INFORMATION:
No acute or chronic toxic effects expected when used according to directions.
12. ECOLOGICAL CONSIDERATIONS:
No ecological or special considerations when used according to directions. Not considered environmentally
harmful from normal dilution, expected usage and typical drainage to sewers, septic systems and treatment
plants.
13. DISPOSAL CONSIDERATIONS:
No special considerations when disposed according to local, state and Federal regulations.
14. TRANSPORT INFORMATION:
Not classified as a hazardous material.
15. REGULATORY AND OTHER INFORMATION:
TSCA: All ingredients are listed or exempt per reference 15 USC 2602 (2)(B)(iv).
Complies with current FDA regulations for cosmetic and/or over-the-counter drug products.
WHMIS: Not Controlled
.
Notice: The information herein is based on data considered to be accurate as of the date of preparation of this material safety data sheet.
However, no warranty or representation, expressed or implied, is made as to the accuracy or completeness of the foregoing data and
safety information. The user assumes all liability for any damage or injury resulting from abnormal use, from any failure to adhere to
recommended practices or from any hazards inherent in the nature of the product.