Pro-Link Magnifico Multi Purpose Cleaner 15976 - Manual

Magnifico
Multi-Purpose Cleaner
NFPA/HMIS :
Health -1
Flammability - 0
Reactivity - 0
Complies With USDL Safety and Health Regulations,
(29 CFR 1910.200)
Material Safety Data Sheet US Department Of Labor
SECTION - 1 CHEMICAL AND COMPANY IDENTIFICATION
PRODUCT USE: All purpose Cleaner
American Formula
4720 Frederick Drive, S.W.
Atlanta, GA 30336
EMERGENCIES: 1-800-255-3924
REVISION DATE: 02/12/09
SECTION - 2 COMPOSITION ON INGREDIENTS
CAS # CHEMICAL NAMES Wt% T LV (UNIT S)
67-63-0 Isopropanol < 3 400 (PPM)
SECTION - 3 HAZARDS INFORMATION
Primary Route(s) of Entry: Skin contact /absorption and inhalation
Signs and Symptoms of Overexposure: Gastrointestinal irritation
(nausea, vomiting, diarrhea), irritation to nose, throat, and respiratory
tract.
T arget Organ Effects: Overexposure to this material (or its
components) has been suggested as a cause of the following
effects in laboratory animals and may aggravate pre -existing disorders
or these organs in humans: chronic ingestion may cause kidney and
liver lesions at high doses.
IMMEDIAT E HEALT H EFFECT S:
EYES: Exposure may cause noticeable pain, and severe irritation and
transient corneal injury.
SKIN: Exposure may cause mild skin irritation. Prolonged or repeated
exposure may dry the skin. Symptoms may include redness, burning,
drying and cracking and skin burns. Additional symptoms of skin
contact may include: allergic reaction. Skin absorption is possible, but
harmful effects are not expected from this route of exposure under
normal handling and use.
INHALAT ION: Exposure to vapor or mist is possible. Short term
inhalation is not likely to cause harmful effects: breathing large amounts
may be harmful. Symptoms are more typically seen at air
concentrations exceeding the recommended exposure limits.
INGEST ION: Single dose oral toxicity is low. Swallowing small
amounts during normal handling is not likely to cause harmful effects:
swallowing large amounts may be harmful.
REPRODUCT IVE / DEVELOPMENT AL INFORMAT ION: No Data
CARCINOGENIC INFORMAT ION: This material is not listed as a
carcinogen by IARC, NTP, or OSHA
LONG T ERM EFFECT S: No Data
SECTION - 4 FIRST AID MEASURES
EYES- Flush eyes with clear water for 15 minutes. Get prompt medical
attention.
SKIN-Rinse with water for 15 minutes. If irritation develops, get medical
attention.
INHALAT ION- If symptoms develop move victim to fresh air. If
symptoms persist, call a physician.
INGEST ION- Immediately give 1 or 2 glasses of water and induce
vomiting by sticking finger down throat. Keep victims head below waist
to prevent aspiration into lungs. Get prompt medical attention.
SECTION - 5 FIRE FIGHTING MEASURES
Flash Point: Explosive limits
No Flash at Boil (C.C. method) Not Applicable
Autoignition T emperature Hazardous Products of
Combustion
Not Applicable Not Applicable
Extinguishing Media Fire Fighting Instructions
Not Applicable Avoid contact with this material.
Avoid walking in spilled material.
Wear protective clothing for skin
and eyes
SECTION - 6 ACCIDENTAL RELEASE MEASURES
Small Spill: Absorb with an inert solid and scoop up for disposal, then
rinse soiled area with water down the drain.
Large Spill:Stop leak at the source and collect into a suitable container,
then treat as a small spill.
SECTION - 7 HANDLING AND STORAGE
Handling: Containers of this material may be hazardous when emptied.
Since emptied containers retain product residues (vapor, liquid, and/or
solid), all hazard precautions given in the data sheet must b e observed.
Storage: Store in a cool, dry place. Keep container closed when not in
use.
SECTION - 8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Eye Protection: Chemical Splash goggle in compliance with OSHA
regulations are advised: however , OSHA regulations also permit other
type safety glasses. Consult your safety representative.
Skin Protection: Wear rubber gloves (consult your safety equipment
supplier). To prevent repeated or prolonged skin contact, wear
impervious clothing and boots.
Respiratory Protection: If workplace exposure limits of product or any
component are exceeded (see exposure guidelines),NIOSH/OSHA
approved air supplied respirator is advised in the absence of proper
environmental control. OSHA relations also permit other NIOSH/OSHA
respirators (negative pressure type) under specific conditions (see
your industrial hygienist). Engineering or administrative controls should
be implemented to reduce exposure.
Engineering Controls: Provide sufficient mechanical (general and local
exhaust) ventilation to maintain exposure below level of overexposure
(from known, suspected or apparent adverse effects).