Pro-Link Urethane 08896 - Manual

Urethane Fortified Finish
NFPA/HMIS : Health -1
Flammability - 0
Reactivity - 0
Complies With USDL Safety and Health Regulations, (29 CFR
1910.200)
Material Safety Data Sheet
US Department Of Labor
SECTION - 1 CHEMICAL AND COMPANY IDENTIFICATION
PRODUCT USE: Floor Finish
Pro Link
510 Chapman Street
Canton, Ma 02021
EMERGENCIES: 1-866-303-6948
REVISION DATE: 02/14/05
SECTION - 2 COMPOSITION ON INGREDIENTS
CAS # Chemical Names Wt% TLV (units)
111-90-0 Glycol Ether DE < 6 N/E
N/E = not established
SECTION - 3 HAZARDS INFORMATION
Primary Route(s) of Entry: Skin contact /absorption and inhalation
Signs and Symptoms of Overexposure: Gastrointestinal irritation
(nausea, vomiting, diarrhea), irritation to nose, throat, and respiratory
tract.
Target Organ Effects: Overexposure to this material (or its
components) has been suggested as a cause of the following
effects in laboratory animals and may aggravate pre-existing disorders
or these organs in humans: chronic ingestion may cause kidney and
liver lesions at high doses.
IMMEDIATE HEALTH EFFECTS:
EYES: Exposure may cause noticeable pain, and severe irritation.
SKIN: Exposure may cause mild skin irritation. Prolonged or repeated
exposure may dry the skin. Symptoms may include redness, burning,
drying and cracking and skin burns. Additional symptoms of skin
contact may include: allergic reaction. Skin absorption is possible, but
harmful effects are not expected from this route of exposure under
normal handling and use.
INHALATION: Exposure to vapor or mist is possible. Short term
inhalation is no likely to cause harmful effects: breathing large amounts
may be harmful. Symptoms are more typically seen at air
concentrations exceeding the recommended exposure limits.
INGESTION: Single dose oral toxicity is low. Swallowing small
amounts during normal handling is not likely to cause harmful effects:
swallowing large amounts may be harmful.
REPRODUCTIVE / DEVELOPMENTAL INFORMATION:
No Data
CARCINOGENIC INFORMATION: This material is not listed as a
carcinogen by IARC, NTP, or OSHA
LONG TERM EFFECTS: No Data
SECTION - 4 FIRST AID MEASURES
EYES- Immediately flush with water. Remove contact lenses if
applicable, and continue flushing with water. Call a physician if
irritation persists.
SKIN- Flush with water. Wash thoroughly with soap and water. Call
physician if irritation persists.
INHALATION- If symptoms develop, move victim to fresh air. If
symptoms persist, call a physician.
INGESTION- Do not induce vomiting. Rinse mouth with water, then
drink one glass of water. Call physician immediately. Never give
anything by mouth if victim is unconscious, is rapidly losing
consciousness or is convulsing.
SECTION - 5 FIRE FIGHTING MEASURES
Flash Point: No Flash at Boil (C.C. method)
Explosive limits: Not Applicable
Autoignition Temperature: Not Applicable
Hazardous Products of Combustion: Not Applicable
Extinguishing Media: Not Applicable
Fire Fighting Instructions: Avoid contact with this material. Avoid
walking in spilled material. Wear protective clothing for
skin and eyes
SECTION - 6 ACCIDENTAL RELEASE MEASURES
Small Spill: Absorb with an inert solid and scoop up for disposal, then
rinse soiled area with water down the drain.
Large Spill: Stop leak at the source and collect into a suitable
container, then treat as a small spill.
SECTION - 7 HANDLING AND STORAGE
Handling: Containers of this material may be hazardous when
emptied. Since emptied containers retain product residues (vapor,
liquid, and/or solid), all hazard precautions given in the data sheet
must be observed.
Storage: Store in a cool, dry place. Keep container closed when not in
use.
SECTION - 8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Eye Protection: Chemical Splash goggle in compliance with OSHA
regulations are advised: however , OSHA regulations also permit other
type safety glasses. Consult your safety representative.
Skin Protection: Wear rubber gloves (consult your safety equipment
supplier). To prevent repeated or prolonged skin contact, wear
impervious clothing and boots.
Respiratory Protection: If workplace exposure limits of product or any
component are exceeded (see exposure guidelines) NIOSH/OSHA
approved air supplied respirator is advised in the absence of proper
environmental control.
OSHA relations also permit other NIOSH/OSHA respirators (negative
pressure type) under specific conditions (see your industrial hygienist).
Engineering or administrative controls should be implemented to
reduce exposure.
Engineering Controls: Provide sufficient mechanical (general and
local exhaust) ventilation to maintain exposure below level of
overexposure (from known, suspected or apparent adverse effects).
SECTION - 9 PHYSICAL AND CHEMICAL PROPERTIES
Appearance and odor: Opaque liquid with an ammonia odor
pH Concentrate: 8.0 - 9.0
Vapor Pressure: Unknown
Vapor Density: Unknown
Boiling Point: 209 Degrees Fahrenheit
Solubility in Water: Emulsion
Percent Volatile: 82%
Specific Gravity:(H2O =1) 1.04 +/- 0.02
SECTION - 10 STABILITY AND REACTIVITY
Chemical Stability: Stable
Conditions to Avoid: Temperature Extremes
Incompatibility: None
Hazardous Decomposition: Will not Occur
Hazardous Polymerization: Will not Occur
SECTION - 11 TOXICOLOGICAL INFORMATION
No Data Available
SECTION - 12 ECOLOGICAL INFORMATION
No Data Available
SECTION - 13 DISPOSAL CONSIDERATION
Waste Disposal Information: Dispose of in accordance with all
applicable Federal, State, and Local regulations.
RCRA Information: If this material becomes a waste, it would not be
considered hazardous under 40 CFR 261.22.
SECTION - 14 TRANSPORT INFORMATION
DOT Information 49 CFR 172.101
DOT Description:33440 Class 55
DOT Hazard Class:Non Hazardous
Hazardous Component:None
Reportable Quantity (RQ) - 49 CFR 172.101
Not Applicable