Chicago Electric 7-1/4" Circular Saw Worm Gear Drive 90186 User Manual

Page 10

SKU 90186

PAGE 10

SYMBOLOGY

Double Insulated

Canadian Standards
Association

Underwriters
Laboratories, Inc.

Volts Alternating Current

Amperes

No Load Revolutions
per Minute (RPM)

xxxx/min.

V ~

UNPACKING

When unpacking, check to make sure all the parts shown on the

Parts List on page 17

and 18 are included. If any parts are missing or broken, please call Harbor Freight Tools
at the number shown on the cover of this manual as soon as possible.

ASSEMBLY INSTRUCTIONS

NOTE: For additional information regarding the parts listed in the following pages, refer
to the

Assembly Diagram on page 19.

Always make sure the Power Cord (part #65) of the Circular Saw is
unplugged from its electrical outlet prior to assembly, adding any accessories, or
making any adjustments to the tool.

To Remove/Install A Saw Blade:

Depress the Lock Button to hold the Saw Blade (part #3) in place. Continue to

depress the Lock Button. Then, unscrew

(clockwise) and remove the Bolt

(part #1) and Outer Blade Press (part #2).

(See Figures D and E, next page.)

Pull the Lower Guard (part #6) all the way up into the Upper Guard (part #21).

Then, remove the old Saw Blade (part #3) and install a new Saw Blade onto the

Shaft (part #15).

NOTE: Make sure to install the new Saw Blade with its

teeth and the arrow on the Saw Blade pointing in the same direction as the

arrow on the Lower Guard. (See Figure F, next page.)

WARnInG