Pro-Link Red Dye Remover 08962 - Manual

1
RED DYE REMOVER
NFPA/HMIS : Health -2
Flammability - 0
Reactivity - 0
Complies With USDL Safety and Health Regulations, (29 CFR
1910.200)
Material Safety Data Sheet US Department Of Labor
SECTION - 1 CHEMICAL AND COMPANY
IDENTIFICATION
PRODUCT USE: Carpet Spotter
PRO-LINK
510 Chapman Street
Canton, MA 02021
EMERGENCIES: 1-866-303-6948
REVISION DATE: 02/14/05
SECTION - 2 COMPOSITION ON INGREDIENTS
CAS # CHEMICAL NAMES Wt% TLV (UNITS)
111-76-2 Glycol Ether EB < 5 25 (PPM) skin
141-43-5 2-Aminoethanol < 2 3 (PPM) TWA
1310-58-3 Potassium Hydroxide < 1 2 mg/ m
3
SECTION - 3 HAZARDS INFORMATION
Primary Route(s) of Entry
Skin contact /absorption and inhalation
Signs and Symptoms of Overexposure
Gastrointestinal irritation (nausea, vomiting, diarrhea), irritation to
nose, throat, and respiratory tract.
Target Organ Effects
Overexposure to this material (or its components) has been
suggested as a cause of the following effects in laboratory animals
and may aggravate pre-existing disorders or these organs in
humans: chronic ingestion may cause kidney and liver lesions at
high doses.
IMMEDIATE HEALTH EFFECTS
EYES: Corrosive. Exposure may cause noticeable pain, and
severe irritation and transient corneal injury.
SKIN: Corrosive. Causes chemical burns. Harmful contact may
not cause immediate pain. Ethylene
glycol monobutyl ether and 2-aminoethanol may be absorbed
through the skin.
INHALATION: Exposure to vapor or mist is possible. Short term
inhalation is no likely to cause harmful effects:
breathing large amounts may be harmful. Symptoms are more
typically seen at air concentrations exceeding the recommended
exposure limits.
INGESTION: Harmful or fatal if swallowed. Causes chemical
burns to the mouth, throat and stomach.
REPRODUCTIVE / DEVELOPMENTAL INFORMATION
No Data
CARCINOGENIC INFORMATION
This material is not listed as a carcinogen by IARC, NTP, or
OSHA
LONG TERM EFFECTS
No Data
SECTION - 4 FIRST AID MEASURES
EYE or Skin Contact: Immediately flush with water for at least 15
minutes. Remove contaminated clothing or shoes. Get medical
attention.
INHALATION: If symptoms develop move victim to fresh air. If
symptoms persist, call a physician.
INGESTION: Do not force vomiting. Drink water. Get medical
attention.. NEVER GIVE ANYTHING BY MOUTH ITO AN
UNCONSCIOUS PERSON.
SECTION - 5 FIRE FIGHTING MEASURES
Flash Point Explosive limits
No Flash at Boil (C.C. method) Not Applicable
Autoignition Temperature Hazardous Products
of Combustion
Not Applicable Oxides of carbon, oxides
of nitrogen, and ammonia
Extinguishing Media Fire Fighting Instructions
Not Applicable Avoid contact with this
material. Avoid walking
in spilled material. Wear
protective clothing for
skin and eyes
SECTION - 6 ACCIDENTAL RELEASE MEASURES
Small Spill Absorb with an inert solid and scoop up for disposal,
then rinse soiled area with water down the drain.
Large Spill Stop leak at the source and collect into a suitable
container, then treat as a small spill.
SECTION - 7 HANDLING AND STORAGE
Handling Containers of this material may be hazardous when
emptied. Since emptied containers retain product residues (vapor,
liquid, and/or solid), all hazard precautions given in the data sheet
must be observed.
Storage Store in a cool, dry place. Keep container closed when
not in use.
SECTION - 8 EXPOSURE CONTROLS /
PERSONAL PROTECTION
Eye Protection Chemical Splash goggle in compliance with OSHA
regulations are advised: however , OSHA regulations also permit
other type safety glasses. Consult your safety representative.
Skin Protection Wear rubber gloves (consult your safety
equipment supplier). To prevent repeated or prolonged
skin contact, wear impervious clothing and boots.
Respiratory Protection If workplace exposure limits of product or
any component are exceeded (see exposure guidelines),
NIOSH/OSHA approved air supplied respirator is advised in the
absence of proper environmental control. OSHA relations also
permit other NIOSH/OSHA respirators (negative pressure type)
under specific conditions (see your industrial hygienist).
Engineering or administrative controls should be implemented to
reduce exposure.
Engineering Controls Provide sufficient mechanical (general and
local exhaust) ventilation to maintain exposure below level of
overexposure (from known, suspected or apparent adverse
effects).