Pro-Link Preference Q - Quanternary Ammonium Cleaner 10028 EN - Manual

PREFERENCE Q
NFPA/HMIS : Health -2
Flammability - 0
Reactivity - 0
Complies With USDL Safety and Health Regulations, (29 CFR
1910.200)
Material Safety Data Sheet US Department Of Labor
SECTION - 1 CHEMICAL AND COMPANY IDENTIFICATION
PRODUCT USE: Detergent Disinfectant
Pro Link
500 Chapman Street
Canton, MA 02021
EMERGENCIES: 1-866-303-6948
REVISION DATE: 09/20/2010
SECTION - 2 COMPOSITION ON INGREDIENTS
CHEMICAL NAMES Wt% TLV (UNITS)
CHEMICAL NAMES Wt% TLV (UNITS)
Didecyl Dimethyl Ammonium Chloride 2.535 N/E
n-Alkyl (C
14
50%, C 12 40%,C
16
10%)
dimethyl benzl ammonium chloride 1.690% N/E
NE: Not Established
NE: Not Established
SECTION - 3 HAZARDS INFORMATION
Primary Route(s) of Entry: Skin contact /absorption and inhalation
Signs and Symptoms of Overexposure: Gastrointestinal irritation
(nausea, vomiting, diarrhea), irritation to nose, throat, and respiratory
tract.
Target Organ Effects: None expected.
IMMEDIATE HEALTH EFFECTS
EYES: Exposure may cause noticeable pain, and severe irritation.
SKIN: Exposure may cause mild skin irritation. Prolonged or repeated
exposure may dry the skin. Symptoms may include redness, burning,
and drying and cracking. Additional symptoms of skin contact may
include: allergic reaction. Skin absorption is possible, but harmful
effects are not expected from this route of exposure under normal
handling and use.
INHALATION: Exposure to vapor or mist is possible. Short term
inhalation is no likely to cause harmful effects: breathing large amounts
may be harmful. Symptoms are more typically seen at air
concentrations exceeding the recommended exposure limits.
INGESTION: Single dose oral toxicity is low. Swallowing small
amounts during normal handling is not likely to cause harmful effects:
swallowing large amounts may be harmful.
REPRODUCTIVE / DEVELOPMENTAL INFORMATION
No Data
CARCINOGENIC INFORMATION: This material is not listed as a
carcinogen by IARC, NTP, or OSHA
LONG TERM EFFECTS: No Data
SECTION - 4 FIRST AID MEASURES
EYES- Immediately flush with water. Remove contact lenses if
applicable, and continue flushing with water. call a physician if irritation
persists.
SKIN- Flush with water. Wash thoroughly with soap and water. Call
physician if irritation persists.
INHALATION- If symptoms develop, move victim to fresh air. If
symptoms persist call a physician.
INGESTION- Do not induce vomiting. Rinse mouth with water, then
drink one glass of water. Call a physician immediately. Never give
anything by mouth if victim is unconscious, is rapidly losing
consciousness or is convulsing.
SECTION - 5 FIRE FIGHTING MEASURES
Flash Point Explosive limits
No Flash at Boil (C.C. method) Not Applicable
Autoignition Temperature Hazardous Products of
Combustion
Not Applicable Not Applicable
Extinguishing Media Fire Fighting Instructions
Not Applicable Avoid contact with this material.
Avoid walking in spilled material.
Wear protective clothing for skin and
eyes
SECTION - 6 ACCIDENTAL RELEASE MEASURES
Small Spill: Absorb with an inert solid and scoop up for disposal, then
rinse soiled area with water down the drain.
Large Spill: Stop leak at the source and collect into a suitable
container, then treat as a small spill.
SECTION - 7 HANDLING AND STORAGE
Handling: Containers of this material may be hazardous when
emptied. Since emptied containers retain product residues (vapor,
liquid, and/or solid), all hazard precautions given in the data sheet
must be observed.
Storage: Store in a cool, dry place. Keep container closed when not in
use.
SECTION - 8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Eye Protection: Chemical Splash goggle in compliance with OSHA
regulations are advised: however , OSHA regulations also permit other
type safety glasses. Consult your safety representative.
Skin Protection: Wear rubber gloves (consult your safety equipment
supplier). To prevent repeated or prolonged skin contact, wear
impervious clothing and boots.
Respiratory Protection: If workplace exposure limits of product or any
component are exceeded (see exposure guidelines), NIOSH/OSHA
approved air supplied respirator is advised in the absence of proper
environmental control. OSHA relations also permit other NIOSH/OSHA
respirators (negative pressure type) under specific conditions (see your
industrial hygienist). Engineering or administrative controls should be
implemented to reduce exposure.
Engineering Controls: Provide sufficient mechanical (general and
local exhaust) ventilation to maintain exposure below level of
overexposure (from known, suspected or apparent adverse effects).
SECTION - 9 PHYSICAL AND CHEMICAL PROPERTIES