Cabletron Systems STARPLUS 2700 Series - Manual (Page 19)

Programming 15
To terminate a conference, placing both lines on Hold:
1. Press the HOLD button.
2. The red Conference LED will extinguish; the LIU LEDs will
illuminate steady red.
3. Both first and second parties will be placed on HOLD.
Programming
To enter programming mode:
1. The telephone line cord must be installed first. Lift the handset.
2. Press and hold the STORE button until a tone is heard.
3. You may now program the Tone/Pulse mode, Flash Timing,
Pause Timing, or Positive Disconnect.
4. Hang-up to end the programming mode. All programming is
stored consecutively after entering the programming mode.
Tone/Pulse
Default setting is TONE.
To set the telephone to PULSE:
1. After entering the programming mode, press [#].
2. A confirmation tone will be heard at the end of the program
sequence.
To set the telephone back to TONE:
1. After entering the programming mode, press [*].
2. A confirmation tone will be heard at the end of the program
sequence.
To program Caller ID model 2706, refer to the “ Caller ID
Operation & Programming ” section.