beautypg.com

Material safety data sheet – Pro-Link DiffuseAire e-Merge Refills DA11-SR EN User Manual

Page 2

background image

MATERIAL SAFETY DATA SHEET

___________________________________________________________________________________
Date of last change August 2014

Page 2 of 4

Skin exposure: Wash affected areas with soap and water for at least 15 minutes. Keep contaminated
clothing away from skin. Contact a physician as necessary.

Ingestion: Give water or milk to dilute. Obtain medical advice immediately. Do not induce vomiting.

Others: In the event of a genuine medical emergency, any additional information will be revealed to a
qualified health professional.




Flash Point: Greater than 212F (100 C) [Est.]
Auto ignition Temperature Not Determined.
Upper Flame Limit (volume % in air): Not applicable.
Lower Flame Limit (volume % in air): Not applicable.
Flame Propagation Rate (Solids): Not determined.
OSHA Flammability Class: None

Extinguishing Media: Dry chemical, carbon dioxide, or foam as appropriate. Avoid using direct
streams of water as it may scatter and spread fire.

Unusual Fire and
Emulsion of spilled product with water can result in slippery
Explosion Hazards: floors and stairs.




In case of spill or other release: Eliminate all ignition sources, Ventilate area, Contain spill and keep
away from heat or flame, prevent from entering sewers, and recover free product with absorbent
material. Collect in approved disposal containers.

Spills and releases may need to be reported to Federal, State, and Local authorities. Always dispose of
material in accordance with applicable laws. Use containers suitable for flammable or combustible
residue.



Handling: Avoid spillage which can cause very slippery conditions on floors and increase vapor
concentration indoors. Use good personal hygiene and housekeeping; always wash hands after handling
products.
Storage:
Avoid excessive heat. Store in a cool dry environment. Do not store near strong oxidizing
agents, any heat source, open flames or other sources of ignition.



Engineering Controls: General room ventilation is adequate for storage and mechanical ventilation is
suggested for enclosed areas where the product may be dispensed from the shipping container.
Eye protection:
Wearing of safety glasses recommended. If possibility of splashing is present, wear
splash goggles or face shield.
Skin protection:
Not normally required. Use of chemically resistant gloves is recommended.
Respiratory Protection:
Not required for properly ventilated areas. If there is a potential for inhalation
of vapor in a closed or poorly ventilated area, a NIOSH approved respirator may be used. The
respirator must be selected based on the contamination levels and use conditions found in the
workplace. Use conditions must not exceed the working limits of the respirator. The respirator must be
used in accordance with the OSHA respiratory protection standard (USA 29 CFR 1910.134).
Additional Recommendations:
Provide safety showers and eyewash stations in close proximity to the
work area.
Exposure Guidelines:
Under normal conditions, no exposure limits are known for these materials.
Decomposition products, including carbon monoxide maybe formed if product is burned.

5.

FIRE FIGHTING METHODS

6.

ACCIDENTAL RELEASE MEASURES

7.

HANDLING & STORAGE

8.

EXPOSURE CONTROLS / PERSONAL PROTECTION