Wilbur Curtis ILGD User Manual
Service manual – digital interlock grinders

CAUTION: Please use
this setup procedure
before attempting to use
this grinder. Failure to follow the
instructions can result in injury or
the voiding of the warranty.
WARNING TO AVOID
SCALDING, Remove
the brew cone carefully.
The brew cone contains hot
coffee grounds. Wait until the
brewer indicates that the brew is
finished before removing.
Service Manual – Digital Interlock Grinders
W
ilbur
C
urtis
C
ompany
, i
nC
.
Models Included
ILGD
1. Lift open the top cover of the grinder and fill with fresh whole
bean coffee. Close the cover.
2. Position an empty coffee container onto the brew deck.
3. Place a new paper filter into the brew cone.
4. Insert the brew cone into the basket holder arms on the
grinder.
5. On the grinder control panel, press the desired grind size/brew
volume button;
SMALL, MEDIUM or LARGE.
6. Make sure the motor comes to a stop before removing the
brew cone.
7. For Interlock brewers: The brew selection is “Locked” into the
brewer, indicated by a flashing LED next to the corresponding
brew button.
8. Transfer the filled brew cone to the brewer and press the de-
sired brew button. The brew cycle is complete when the brew
light stops flashing.
Important Safeguards & Symbols
This appliance is designed for commercial use. Any servicing other than cleaning and
maintenance should be performed by an authorized Wilbur Curtis service technician.
• Do NOT immerse the unit in water or any other liquid
• To reduce the risk of fire or electric shock, do NOT open top panel. No user serviceable
parts inside.
• Keep hands and other items away from hot parts of unit during operation.
• Never clean with scouring powders or harsh chemicals.
SYMBOLS
WARNINGS – To help avoid personal injury
Important Notes/Cautions – from the factory
SETUP STEPS
1. Install the grinder on a firm, level base in a location where it can be connected to a
grounded electrical outlet of 120VAC, rated at 15 amps minimum.
2. Test the unit by running some whole bean coffee through the grinder. If any problems
are encountered, refer to the troubleshooting section complete at www.wilburcurtis.com
or call Technical Support at 800-995-0417.
3. Interlock Connection: If hooking up the brewer and grinder for the Interlock option,
locate the jack on back of the brewer marked CLASS 2 WIRING. Plug in the Interlock
cable from the grinder into this jack on the brewer.
OPERATING INSTRUCTIONS
ISO 9001:2008 REGISTERED
WILBUR CURTIS CO., INC.
6913 West Acco Street
Montebello, CA 90640-5403
For the latest information go to
www.wilburcurtis.com
Tel: 800-421-6150
Fax: 323-837-2410