Wilbur Curtis SD2 - Manual (Page 2)

Enter Program Mode – press and hold STOP/WASH for about ten [10] seconds until all lights
start blinking.
To program Product % Ratio, press and hold the selected PUSH button for approximately one
second, then release. The current setting will be indicated by LED flashes.
To change the product throw, press and hold the button until light starts quick flashing. Each quick flash increases
the amount by 10%. Release the button when the desired throw amount is achieved. After releasing the button, the
number of blinks represent the new setting.
To exit the Powder Dispensing Mode, push the other PUSH button.
Steps to Programming
2
Your Curtis Cafe System is Factory Pre-Set for Optimum Performance. Usually this Does Not Change.
Number of
Flashes
10%
20%
30%
40%
100%
1
2
3
4
10
Volume
Product % Ratio
This controls the amount of dry product that is metered from the hoppers. This can be programmed from 10% to 100% of the capacity of the
dispensing system. By counting LED flashes you can determine the product % ratio currently set for this dispense button (see table).
Portion Control Liquid Dispensing Mode
This program adjustment allows you to setup the machine to automatically dispense a preset volume of coffee. When the user makes a PUSH
button selection, the SD2 unit dispenses only the volume of coffee programmed by the Portion Control Dispensing Mode. By setting the unit for
Portion Control Dispensing, you have locked out the manual dispense feature.
Enter Program Mode – press and hold STOP/WASH for about ten [10] seconds until all lights start blinking.
To select & change the Portion Control Dispensing Volume – while in the programming mode, press and hold the
selected PUSH button until the liquid begins to flow, then release. The timing starts when liquid begins to flow.
Stop flow and Exit – When the desired volume is achieved, press this PUSH button once again to stop the dispensing.
You have now set the timing for this button and have exited the programming mode. Pressing the selected dispense
button now will provide the liquid volume that you just set. To reset the timing, you must start again by entering the
programming mode.
WARNING HOT LIQUID, Scalding
may occur. Avoid splashing.
Place an empty container under the
dispensing nozzles while programming.
All programming is performed at the control panel
(illustration, right).
The Hot Water button is used for only for dispens-
ing hot water and does not require any program-
ming. Water is dispensed as long as the Hot Water button is held down.
The STOP/WASH BUTTON has several functions. This button is used to stop a Portion Control dispense cycle. It is used to wash out the mixing
and dispensing systems and it is used to enter programming functions.