Wilbur Curtis GEMTS - Manual (Page 5)

5
Model Select
Error Message
An error message will appear on the screen in
the event of a malfunction under the following
conditions:
1. Water Level Overflow.
2. Break in Temperature Control Circuit
3. Excess Temperature in Heating Tank
To turn off an error message, press the  button
for five seconds.
Model Select (Factory set to Gemini-Twin IF)
Press  to select, < or > to select model. The selections are: ThermoPro‑Twin, ThermoPro‑Single, Gemini‑Twin, Gemini‑
Single, Milano‑Twin, Milano‑Single, Gemini‑Twin IF, Gemini‑Single IF, Tpro‑1Gal‑Twin and Tpro‑1Gal‑Sngl. Press  to set.
When the Model Select feature is changed, all settings are reset to the defaults of the newly selected model.
Language (Factory set to English)
Press  to select, < or > to select language. The selections are: English or French. Press  to set. When the Language
feature is changed, all screens will read the selected language.
Language
Rough-In Drawing
Warmers
The warmer, under the brewcone will turn on automatically whenever
a coffee brew cycle is started. The warmers can be switched on or off
at the two WARMER buttons on on the control panel.
LEFT & RIGHT
SATELLITE WARMERS
29.63”
(75.3 cm)
4.00”
(10.1 cm)
6.75”
(17.1 cm)
5.38”
(13.7 cm)
11.00”
(27.9 cm)
11.13”
(28.3 cm)
1.00”
(2.54 cm)
18.13”
(46.0 cm)
22.13”
(56.2 cm)