Wilbur Curtis TP2S – ThermoPro Single - Manual (Page 2)

Your Curtis ADS System is Factory Pre‑Set for Optimum Performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.
The control displays . Press ON/OFF button and the screen will display . After three seconds, is displayed.
Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached will appear on the screen.
It takes approximately 20 minutes to reach setpoint temperature of 200°F.
Control will display when temperature reaches the setpoint (200°F); unit is at brewing temperature.
THERMOPRO
WILBUR CURTIS
WILBUR CURTIS WILBUR CURTIS
FILLING . . .
WILBUR CURTIS
HEATING . . .
WILBUR CURTIS
READY TO BREW
2
BREWING INSTRUCTIONS
1. Brewer should be ON (Confirm at rear toggle switch, then press the ON/OFF button). Screen should read Ready-to-Brew. If connected to an
InterLock grinder. Grinder should be on.
2. Place an empty ThermoPro server centered beneath the brewcone.
6. Select and press desired
brew button. Brewing will
begin immediately.
5. Transfer filled brewcone
to the brew rails.
3. Place a clean filter into
the brewcone.
4. Fill brewcone with the
proper amount of ground
coffee. If Interlocked,
fill the brewcone at the
grinder.
WARNING TO AVOID SCALDING, Do not remove brewcone while brew light is flashing.