Assembly – Ryobi RY60520 User Manual
Page 8
8
POSiTiONiNG THE HANDLEBAR
See Figure 2.
Loosen the two handlebar knobs.
Unfold the handlebar into operating position.
NOTE: Do not use force. If there is binding, continue to
loosen the knobs. Do not allow throttle cable to become
pinched when raising the handlebar.
Retighten the handlebar knobs.
UNPAcKiNG
This product requires assembly.
Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PAcKiNG LiST
Cultivator
Drag Bar
Pull Pin
Hitch Pins ()
Felt Washers ()
Inner Tines ()
Outer Tines ()
Ryobi Exact Mix -Cycle Oil
Wheel Assembly (Accessory)
Operator’s Manual
WARNiNG:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Failure to heed
this warning could result in serious personal injury.
WARNiNG:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
ASSEMBLY
Fig.
HANDLEBAR
HANDLEBAR
KNOBS