Ryobi RY60520 - Manual (Page 11)

11
WARNiNG:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNiNG:
Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNiNG:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNiNG:
Do not allow hands, feet, or any other part of the body
or clothing near the rotating tines or any other moving
part. The tines begin to rotate forward once the engine is
started and the throttle lever is depressed. The tines con-
tinue to rotate until the throttle lever is released. Failure to
avoid contact could cause serious personal injury.
ASSEMBLY
ADDiNG SAND
See Figure 8.
The cultivator is equipped with a Just Add Sand
™ weight
system, which improves the stability of the unit during op-
eration. The added weight of the sand also helps you work
with less effort and vibration.
To add sand:

Lift the lid of the Just Add Sand ™ tank and remove.
 Pour dry sand into the tank. The tank will hold approxi-
mately 13 pounds of sand.
NOTE: Be careful not to pour sand into or onto the engine
housing.
 Replace Just Add Sand ™ lid.
Fig. 8
OPERATiON
APPLicATiONS
 Breaking up garden soil to prepare seed bed for planting
 Shallow cultivating to remove weeds
STARTiNG/STOPPiNG THE
cULTivATOR
See Figures 9 - 12.
Starting the product differs depending on whether the engine
is cold or warm. Refer to the label on the air filter cover.
To Start a cold Engine:

Lay the product on a flat, bare surface.
 Toggle the switch to the i (ON) position.
 Slowly push the primer bulb seven times.
JUST ADD SAND ™
LID
Fig. 9
ENGINE
SWITCH