Cabletron Systems BRIM-T6 - Manual (Page 9)

1-1
CHAPTER 1
INTRODUCTION
Welcome to the BRIM-T6 USER’S GUIDE . This manual describes
BRIM-T6 features, installation instructions, and operating procedures. It is
intended for all users of the BRIM-T6.
1.1 USING THIS MANUAL
If you are unfamiliar with Cabletron Systems’ networking products, please
read this manual completely to gain an understanding of the features and
capabilities of the BRIM-T6. Also, you should have a general knowledge
of Token Ring (IEEE 802.5) data communications networks and their
physical layer components before operating the BRIM-T6.
This manual is organized as follows:
Chapter 1, Introduction , outlines the contents of this manual and
discusses BRIM-T6 features, capabilities, and specifications. It also
describes how to get technical help and lists related documentation.
Chapter 2, Installation , describes how to configure and install the
BRIM-T6 and Token Ring Port Interface Modules (TPIMs).
Chapter 3, Connecting to the Network , describes how to establish the
physical link to a Local Area Network (LAN) by connecting standard
network cable segments to the BRIM-T6.
Chapter 4, Monitoring and Troubleshooting , describes how to use the
LANVIEW LEDs diagnostic system to monitor the BRIM-T6’s
operational status. It also describes procedures for resolving problems
encountered establishing a link to a network via the BRIM-T6 interface.
Appendix A, TPIM Specifications , describes specifications for Cabletron
Systems’ series of attachable TPIMs.
Appendix B, Media Specifications , describes specifications for network
media.