Petsafe Stubborn Dog Add-A-Dog® Extra Receiver Collar - Manual (Page 6)

6 1-800-732-2677
Operating Guide
Prepare the Receiver Collar
Your Receiver Collar comes with Contact Points installed. Tighten the
Contact Points using the Test Light Tool to one-half turn beyond fi nger
tight (1A). Check the tightness weekly.
To Insert and Remove the Battery
1A
Note: Do not install the battery while the Collar Receiver is
on your pet.
Remove the screws with a Phillips screwdriver. 1.
Remove the Battery Lid ( 2. 1B).
Install a 9-volt alkaline battery ( 3. 1C).
Replace the Battery Lid ( 4. 1C).
Reinstall the screws. 5.
Do not over-tighten the screws.
1B 1C
Replacement 9-volt alkaline batteries can be found at many retailers.