Petsafe ST-70, 70 m Basic Remote Trainer - Manual (Page 7)

www.petsafe.net 7
DE
NL
IT
FR
ES
EN OPERATING GUIDE
Prepare the Remote Transmitter
To Insert and Remove the Batteries
1. Slide off the battery cover (1A).
2. Install two (2), 3-volt lithium CR2032 batteries positive (+) side up (1B).
3. Slide the battery cover back in place (1C).
To Verify the Batteries are Inserted Correctly
1. Press any button on the Remote Transmitter.
2. The Remote Transmitter LED should fl ash to indicate a button has been pressed.
3. If the Remote Transmitter LED does not fl ash, you may have inserted the batteries backwards.
Try taking them out and turning them over, ensuring that the positive (+) side is up.
4. If the Remote Transmitter LED still does not fl ash, contact the Customer Care Centre.
Risk of explosion if batteries are replaced by an incorrect type. Do
not short circuit, mix old and new batteries, dispose of in fi re, or
expose to water. When batteries are stored or disposed, they must
be protected from shorting. Dispose of spent batteries properly.
Remote Transmitter LED - Function and Response
Function LED Light Response
Unit is on On for length of button press
Low battery condition LED fl ashes 3 times every 5 seconds
STEP 1
1C 1A 1B