Petsafe Pawz Away® Extra Receiver Collar User Manual

Page 10

1-800-732-2677

To assure a proper fit, please follow these steps:

1. Using the edge of the Test Light Tool, turn the battery door to the OFF

position.

2. Start with your pet standing comfortably (4A).
3. Place the Receiver collar on your pet so that the PetSafe

logo is facing

your pet’s chin. Center the Contact Points underneath your pet’s neck,

touching the skin. If your pet has a long or thick coat then it may be

necessary to trim the hair around the Contact Points to make sure that contact is consistent.

Note: The Receiver Collar comes with Short Contact Points. Long Contact Points are

available and can be purchased through the Customer Care Center.

4. Adjust the tightness of the Receiver Collar to fit your

pet’s neck. Check the tightness of the Receiver Collar

by inserting one finger between the end of a Contact

Point and your pet’s neck. The fit should be snug but not

constricting (4B).

5. Allow your pet to wear the Receiver Collar for several

minutes then recheck the fit. Check the fit again as your

pet becomes more comfortable with the Receiver Collar.

6. Once you are satisfied with the fit of the Receiver Collar

then you may trim any excess collar strap as follows (4C):

a. Mark the desired length of the Receiver Collar with a

pen. Allow for growth if your pet is young or grows a

thick winter coat.

b. Remove the Receiver Collar from your pet and cut off the

excess.

c. Before placing the Receiver Collar back onto your pet, seal the edge of the cut collar by

applying a flame along the frayed edge.