Petsafe Pawz Away® Extra Mini Pet Barrier - Manual (Page 16)

16 Customer Care Center 1-800-732-2677 www.petsafe.net 17
To prevent an unintended correction, do not perform set up procedures while the
Receiver Collar is on your pet.
1. Gather the Receiver Collar(s) you wish to synchronize with the Barrier
Transmitter. Turn the Receiver Collar(s) ON and place less than one foot
from the Barrier Transmitter.
2. Turn the Barrier Transmitter OFF by pressing the (-) button until there
are no bars displayed in the LCD window. Remove the back cover.
3. The mode switch is located inside the transmitter and is preset to mode
A. Move the switch to the center position for mode B or to the right
position for mode AB (4A). Once you have selected the desired mode,
replace the back cover.
Note: If you have selected mode AB you do not need to proceed with programming
the receiver in the next steps. Receiver Collars set to mode A or mode B will each
receive the radio signal from a Barrier Transmitter set to mode AB.
Inside
Back
Cover
Transmitter
Inside
View
4A