Petsafe DIY Box Kennel - 2.29 m (W) x 2.29 m (D) x 1.82 m (H) - Manual (Page 2)

-2-
Step 2 Assemble kennel on a level surface.
Gather four corner rails. Point all swedged
(narrowed) ends clockwise.
Step 3 Connect the bottom frame.
Slip swedged ends of tubing
into the next piece of tubing.
Step 4 Add uprights.
Gather: four uprights, eight clamps, four
medium bolts, four small nuts and a 1 /
2
”
wrench.
With the nut on top, clamp all
posts to the bottom frame at
each corner (as shown
below)
Note: All swedged
joints will be loose until
fence fabric is installed.
Step 6 Check that all posts
are straight up and down.
Step 5 Add top rails. Point all top rail
swedges clockwise as the bottom frame.
Connect them as shown to all posts. Tighten
all clamps as you go.
Step 7 Add an upright post for the gate.
The gate can be put 22 1 /
4
” to either side of
any of the post. Do NOT have the gate
span a joint in the frame. The frame can
come apart at the swedged joint.
Gate Opening:
22 1 /
4
" between posts.
Stand corner posts
up and tighten
clamps.