Petsafe Aluminium Pet Door - Manual (Page 3)

Before installing your pet door please
read the following step-by-step
instructions carefully.
Tools required
• Pencil
• Ruler
• Jig or Keyhole Saw
• Drill
• Screwdriver
• Tape measure
• Sand paper
Measurement and marking
Measure the belly height of your pet. (Fig. 1).
Mark this measurement on the outside of your door and draw a straight
horizontal line. (Fig.2).
Please bear in mind that this line will eventually be the bottom of the
hole you will cut in your door and that the frame of the cat fl ap will be
slightly lower. If necessary, this line may have to be raised slightly to
account for this.
FIG.1 FIG.2
Cutting a hole for your pet door
a) In Wood and PVC/uPVC/Metal
The hole that you cut will depend on the size of pet door you have purchased:
Small: 245mm x 150mm (9 5 /
8
” x 5 7 /
8
”)
Medium: 348mm x 225mm (13 3 ⁄
4
” x 8 7 /
8
”)
Large: 451mm x 277mm (17 3 ⁄
4
” x 10 7 /
8
”)
Extra Large: 642mm x 366mm (25 1 ⁄
4
” x 14 3 /
8
”)
All dimensions are displayed
height x width (Fig. 3).
Not to scale - for best results you should refer
to the enclosed cutting template.
(X)
X
Wooden doors PVC/uPVC/Metal
Height
Width
FIG.3
2