PDR Mounts iwbb1614 User Manual

Page 5

INSTALLING THE IN WALL BOX IWBB-1614

1: There are 4 knock outs in the in wall box (2 top and 2 bottom) for the use of the carlon elec. box (item 4)
2: Determine the location of the power and video cables and remove the desired knock outs (tap out with a hammer and twist to remove)
3: Pull the wires thru the knock outs and place the IWBB-1614 into the wall.
4: Push the box into the drywall cut-out

and

lag bolt locations

5: Using the lag bolts (items 2), fasten thru the drywall and into the wall studs.
6: Push the right side flush to the drywall and fasten the lag bolts. The slots allow the metal to bend and conform to the stud spacing
7: Pull the cables thru the carlon boxes and place the box into the knock out hole and fasten with the carlon screws attached to the box.
8: Box covers and plugs for the electrical and video (not supplied ) can be purchased from your local hardware store
9: Place the cable ties( item 3) into the desired pre drilled hole in the back of the box. Use cable ties (not included) to tie up cables.

against the flange,

drill a 1/8” pilot hole on all 4

Wood studs

Lag bolt
Item 2

Carlon wiring box
Item 4

Drywall

Cable tie holders
item 3

Knock outs
top and bottom

Cut out