PDR Mounts pdm110f - Manual

M odel
Thank you for purchasing the PDR panel display wall mount.
To ensure the correct usage, please read and follow the instructions manual thoroughly. Please store the instructions in a safe place for future reference.
To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the weight of both the panel
display and the wall mount.
Always use at least two persons for all installations.
Fully tighten all of the mounting screws as specified in the installation instructions.
Parts Configuration Chart Features
Mounting points for panel display models
Special techniques are necessary for installation of the panel display mount.
Do not attempt to perform this work by yourself.
Request an installation specialist to install this unit.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
Please remember that if you remove the panel display from the wall later, you will find the screw holes and anchor bolts for the
mounting unit left on the wall. Also note that long use of the panel display may discolor the wall around it due to its heat and
airflow.
Low profile 1 5/8”
16" or 24" stud mounting points ( MODEL #110 )
Easy installation
Flat or 5 deg tilt (no tools required)
Lateral movement from center for better viewing position
Wall mount bracket…1 pc
A
B
D
E
5 mm x 16 mm Phillip screws…4 pcs
5/16" x 2 1/2” Lag bolts …4 pcs
Display bracket .... 2 pcs
G
F
K
L
M
O
P
C
6 mm x 16 mm Phillip screws…4 pcs
5/16" Flat washers…4 pcs
H
J
1
Model # 110 = 32” Model # 120 = 24”
Square multi-mount washers...4 pcs
Model # 110 = 20” Model # 120 = 14”
See Model
I
Panel Display mounting slots
See model #
Fig 1
Mounts by
A division of David Engineering & Mfg. Inc.
PDM 110/120F PANEL DISPLAY MOUNT
Locking bar... 1 pc
Top
Bottom
8 mm x 16 mm Phillip screws...4 pcs
8 mm x 40 mm Phillip screws...4 pcs
4 mm x 16 mm Phillip screws...4 pcs
Plastic spacer 3/4 x 1”...4 pcs
Use with #110 Use with #120
6mm x 40 mm Phillip screws...4 pcs
5 mm x 40 mm Phillip screws...4 pcs
4mm steel flat washer...4 pcs
All PDR mounts and adapters carry a limited lifetime warranty from ship date against defects in material and workmanship.
Check the PDR website for details @
www.PDRmounts.com. We are not liable for improper installation that results in damage
to mounts, adapters or presentation equipment.