PDR Mounts pdm120thn - Manual (Page 3)

16 "
24 "
4.00
EQUAL
SPACING
WOOD STUDS
1. FASTEN MOUNTING PLATE TO WALL
Fig 2 Fig 3
2. SECURE THE DISPLAY BRACKETS TO THE MO NITOR
NOTE: Do not over tighten the bracket mounting screws as damage to the display internal mounting threads could occur.
FLOOR LINE
VIEWING
HORIZONTAL
CENTER LINE
(std construction 2 x 4 studs/1/2” wallboard)
Fig 4
3
Mounting hardware F,G ,H,J,K,M,N and O
Square Multi-mount washer ( I )
Panel display bottom edge
Display bracket ( A )
Optional plastic spacers ( L )
The bracket must be secured to the center of the wall studs capable of at least four times the
weight of the unit. Use a stud finder to determine the stud center line of the wall stud.
The wall bracket should be mounted at the same horizontal center line as the display center line.
Pre drill 3/16” (5 mm) holes for the lag bolts
Fig 2.
With the flange facing up on the wall plate, (See
Fig 3) Use the four lag bolts (e) and washers
supplied (d) level and secure the mounting plate to the center of the wall studs.
Place the display panel face down on a protected surface.
Position the bracket (A) with the slots facing towards the top
See Fig 4
Using the proper screws and the square multi-mount washers supplied ( F,G,H,J,or K and I)Position the
brackets equal distance from the bottom and top ,tighten hardware.
NOTE : In some applications the plastic spacer ( L )and longer screws ( J or K )may be required to add clearance
for the back panel.
Do not over tighten hardware, damage to the display may result.
Flange up
Enlarged view