MK Diamond MK-101 - Manual (Page 20)

20
MK-101 SeTUP
Prior to beginning work, a pre-start inspection of the saw should be performed.
1. To prevent the possibility electrical shock, the MK-101 MUST be
de-energized when connecting the Water Pump.
2. To prevent the possibility of electrical shock, use only MK Diamond qualified
replacement parts
NOTe: To prevent pump damage, the Water Pump must be disconnected if cutting with a Dry Blade.
(A)
Ensure the ON/OFF Switch is in
the OFF position
(B)
Verify the Movable Cutting
Table moves freely
(C)
Inspect the Diamond Blade for
damage – verify the blade is
correct for the material being cut
(D)
Inspect the Pump Assembly for
damage – ensure the cord is
free of cracks or cuts
(E)
Inspect the MK-101 for damage
waRNiNG
PRe-STaRT iNSPeCTiON
CONNeCTiNG THe waTeR PUMP
(A)
Connect the Cooling Trans-
fer Tube to the inlet connec-
tion of the Blade Guard
(B)
Connect the Water Pump power
cord to the connection found on
the back of the motor