MK Diamond MK-101 - Manual (Page 14)

14
NOTe: The MK-101 is not designed to cut plastic or ferrous (metals) material.
The MK-101 is a versatile Tile Saw. Operated and used according to this manual, the MK-101 will
provide years of dependable service.
Voltage 120V
Overall amperage 13
Motor Only amperage 14.5
Frequency 60 Hz
RPM 3400 rpm
Horse Power 1.5 hp
weight 92 lbs
MK-101 SaFeTY
PRODUCT SPeCiFiCaTiONS
The MK-101 Tile Saw is engineered as a tabletop or stand mounted wet tile saw. The saw includes a
powerful 120V totally enclosed capacitor start Baldor motor with a thermal protective overload. The
saw is capable of cutting tile up to twenty (20) inches in length, or diagonal cutting tile up to fourteen
(14) inches. The saw can cut an object three (3) inches thick in one pass.
Motor specifications for the MK-101 are listed in table below.
The motor is protected by a thermal overload equipped with a manual reset.
Motor Specifications
Thermal Overload Protection
General Specifications
Blade Capacity
The MK-101 uses a ten (10) inch (254mm) diameter, wet cutting continuous rim, diamond blade with
a five-eighths (5/8) inch (15.875 mm) arbor.
Tile Types
The MK-101 can cut a variety of tile types including Porcelain, Terracotta, Marble, Quarry and Slate,
or almost any other non-ferrous material.
A
B
D
C
E
J
I
H
G
F
A Motor
B Water Pump Tube
C Blade Guard
D Cutting Table
E Water Basin
F Frame
G Guide Bar
H Post
I
Depth of Cut Adjustment Knob
J Belt Guard