MK Diamond MK-377EXP - Manual (Page 20)

20
SETUP FOR OPERATION
1. Before connecting the MK-377EXP to a power supply, be sure the voltage,
cycle and phase meet the requirements of table below.
2. If using an extension cord, make sure the length and wire gauge
correspond to the requirements listed in the table on page 10. An extension
cord that is too small in wire gauge (diameter), or too long in length, will
cause the motor to overheat and could cause premature failure.
3. Before connecting the MK-377EXP to a power supply, be sure the voltage,
cycle and phase of the job site power source meet the requirements in the
table below.
4. Use an approved Ground Fault Circuit Interrupter (GFCI).
5. Do not cover the motor vents as this could lead to motor overheating.
VOLTAGE 120v
CYCLE 60Hz
PHASE 1-phase
In order to avoid breaker tripping, a 20 amp circuit breaker should be used. NOTE:
(A)
Plug MK-377EXP into the
GFCI (A GFCI should always
be used when operating the
MK-377EXP)
(C)
Plug the GFCI into the
power source
CAUTION
MK-377EXP SAW OPERATION