Magnum Dynalab MD-809T - Manual (Page 24)

- 24 -
24
DIGITAL INPUT /OUTPUT
CONNECTING TO AN EXTERNAL DAC
( digital to analog device)
Using a good quality digital cable connect from the digital outputs on the back of the MD unit
either ( RCA or optical ) to the DAC
CONNECTING TO ANOTHER DIGITAL
SOURCE;
Connect a digital cable from you digital source to the digital connector on the back of the MD
809 T , move the switch on the back of the unit to digital. The digital signal will now be sent
through the DAC inside the MD 809T
.The remote control will control the
digital inputs on the back of the unit ,
# 1 is for the tuner , # 2 is for digital
one , # 3is for digital 2 and #3 is for
digital three . To go back to the tuner
you need to push # 1 on the remote
hand held