8a 18, Ab c – Char-Broil T-47D 463251012 User Manual

Page 23

Insert sideburner into left shelf. The stud on bottom of burner fits into rear small hole in sideburner drip pan on shelf,
shown A. Make sure burner tube engages sideburner valve, shown C. Secure burner to siderburner drip pan with one Wing
nut, shown B. Under sideburner shelf, attach sideburner ignitor wire to electrode.

sideburner

Wing nut

electrode

ignitor wire

sideburner drip pan

burner tube

valve

#8-32x3/8” screw

4mm

lock washer

Control knob

Side burner

bezel

First, remove the two screws and lock washers attached to the sideburner valve bracket. Position sideburner valve
bracket beneath sideburner control panel so that valve stem comes through larger center hole in control panel. Align the
holes on valve bracket with left and right holes on control panel. Secure using lock washers and screws that were removed
from bracket.
Next, place sideburner bezel over valve stem on front side of control panel. Align small holes on bezel with upper and lower
holes on control panel. Attach using two #8-32x3/8” screws and 4mm lock washers. Press sideburner control knob onto
valve stem.

Sideburner

valve bracket

Sideburner

control panel

Valve stem

Screws and Washers

removed from valve bracket

Note: Use left and right

holes on control panel

to attach valve bracket

holes on control panel

to attach bezel

Note: Use upper and lower

Note: Make sure to set the bezel with

the longer slot at the top