M2TECH Joplin - Manual (Page 6)

JOPLIN
384
k H z /32bit ANALOG-TO-DIGITAL CONVERTER
REVISION P R B – SEPTEMBER 2012
Copyright © 2012, M2Tech Srl
6
M2Tech
www.m2tech.biz
1. Unpacking and placing the unit
Place the carton box on a table and open it by removing or cutting the adhesive tape.
Extract the foam upper cover. You should find the following items:
• one Joplin ADC;
• one wall adapter;
• one A-B USB cable;
• a remote control.
Should one or more items be missing, please contact your dealer or local distributor.
Extract the Joplin from the foam container and place it on a stable base, far from heat
sources. Avoid the direct sunlight on the unit. Allow for enough room around the unit for
venting. The Joplin is a high efficiency design so little heat is produced during normal
operation; anyway, it’s better allow for adequate venting. Avoid smoke, humidity, moisture
and water from reaching the unit.
Do not place the unit on thick carpets or inside a box or piece of furniture, or in close
contact with curtains.