M2tech, Connection to the host – M2TECH hiFace User Manual

Page 6

Text mode
Original mode

ace

192

/24bit digital audio interface

REVISION 1.o – NOVEMBER 2010

M2Tech

www.m2tech.biz

2. Connection to the host

Please refer to section 1, “Connections”.

Connect the hiFace to the host USB 2.0 port by inserting its USB plug (Figure 1, 1) into the
host socket. If straight insertion is difficult or when in need of avoiding straight insertion, an
USB 2.0 extender cable (A male to A female) can be used. Please avoid using extenders
more than 4m, to avoid invalidating the bus performance.

If a driver hasn’t been installed on your computer, an automatic driver installation wizard
may appear.

Note: If you want to avoid the automatic driver installation, please connect hiFace to
the computer after manually installing the driver (see section 3).