Hit Products Pro-Two User Manual

Page 20

WWW.RAINPROCO.COM

PRO 2

WWW.RAINPROCO.COM

PRO 2 Decoder Programming Instructions

1. Set the controller in the Off position, Turn the rotary switch to position #11
(Rain Off Auto On/Off) use the (SET 4) arrow key to turn the setting from
ON to OFF.
This will stop any program that is running and prevent any from starting while
programming decoders.
2. Disconnect the 2 field wires if connected at the Terminal marked Line Out.
3. Set the Rotary switch to the “Run” position. Position 12.
4. Press (SET 1) arrow key up to access the Set Decoder ID screen.
5. Connect the two red wires of the decoder to the programming port at the bottom of
the controller board marked

One Red wire in each of the Terminals

marked Red.
Connect the decoders’ 2 black wires to the position marked “check”. One black wire
each in the Terminals marked Black. See below.
6. Using the arrow key corresponding directly underneath the ID number in the
Display (Set 2) arrow key select the desired number for that decoder.
7. Press the arrow key corresponding to “ENTER” on the display (right up SET 4).
8. The LED on the controller marked “PROGRAMMING LED” will flash 3 times.
9. Remove the red and black leads.
10. Install “decoder number identification tag”
11. If programming more than one decoder repeat from step 5.
12. To end programming press (SET 1) down arrow key. Controller will
not resume “RUN” automatically.
13. Re-connect the field wires.
14. Set the controller back to ON to resume Auto programming.

Set the controller back to ON to resume Auto programming.

Rotate the dial to

position #11. Press (SET 4) arrow key to turn the setting from OFF to ON.
15. Rotate Dial to Run position #12.

Note:
DO NOT PROGRAM DECODERS WITH SOLENOIDS CONNECTED.
SEE FOLLOWING PAGE