beautypg.com

Honeywell – Bradford White M-2-TW-75T6SX User Manual

Page 35

background image

35

Hotter water increases the risk of scald injury. Scalding may occur within
five (5) seconds at a temperature setting of 135°F (57.3°C). To protect
against hot water injury, install an ASSE approved mixing valve in the water
system. This valve will reduce point of discharge water temperatures by
mixing cold and hot water in branch water lines. A licensed plumbing
professional or local plumbing authority should be consulted.

Note: This water heater is equipped with an energy cut out device to prevent
overheating. Should overheating occur, turn off the electrical supply to the
water heater and contact a qualified service technician.

Thermostat Adjustment

The thermostat dial is adjusted to approximately 120°F (49°C) when shipped
from the factory. When adjusting the thermostat, it should be remembered that
lower temperature settings are more energy efficient. To adjust the thermostat
turn the dial clockwise until the minimum acceptable temperature is set. It is
suggested that the starting point setting not exceed the 120°F (49°C) or “HOT”
setting on the thermostat.

SWITCH SHOWN

IN "ON" POSITION

THERMOSTAT

DIAL

ON

OFF

STATUS

Honeywell

Figure 11

DANGER

This manual is related to the following products: