Auralex Snap-on Anchor User Manual
Snap-on anchor

Screw the Snap-On
Anchors into the back
of the panel using the
Snap-On Hex Driver
tool.*
➊
* TIP: Sometimes it helps to cut the panel to get the anchor started.
This can be done with a utility knife.
NOTE: Snap-On Anchors should only be used with 2” ProPanels.
DO NOT USE with 1” ProPanels.
1164-609.Snap-On Anchor User Guide (10/22/2013 - 2:28 PM)
➍
Screw ratchet plugs to
wall at marked locations.
(**Number of screws
varies with panel size.)
Insert marking plugs into
the Snap-On anchors.
➋
** Recommended quantity of Snap-On Anchors
and screws to panels
Panel Size
Qty
2x2 4
2x4 4
4x4 4
4x8 8
Push panel against
wall to mark anchor
locations.
➌
➎
Firmly push panel
onto ratchet plugs to
complete installation.
Snap-On
Anchor
Snap-On
Marking Plug
Ratchet
Plug
Snap-On Hex
Driver
USER GUIDE
Auralex
®
Acoustics, Inc.
1-800-959-3343 / 317-842-2600 / Auralex.com
9955 Westpoint Drive, Suite 101, Indianapolis IN USA 46256
Snap-On Anchor