Allen&Heath ZED POWER - Manual (Page 16)

Allen & Heath 16 ZED POWER 1000
Mic Input Socket
Standard 3-Pin XLR socket wired as Pin 1=Chassis, Pin 2=hot
(+), Pin 3=Cold (-).
Line Input Jack Socket
Standard 1/4” (6.25mm) Jack socket for balanced or unbalanced
line level signals. Wired Tip=Hot(+), Ring=cold (-),
Sleeve=Chassis.
The Line input connects to the XLR input through a circuit, so be
aware that the two signals will add together if both inputs are
plugged in simultaneously.
Gain Control
This adjusts the gain of the input amplifier to match the signal
level of the source. The gain is varied from +10dB to +60dB for
signals plugged in to the xlr socket (Mic Input) and –10dB to
+40dB for signals plugged into the Line input jack.
100Hz Hi-pass Filter
The Hi-pass filter is used for reducing pop noise and rumble from
microphone signals. It is a single pole (6dB per octave) filter with
a corner frequency set at 100Hz.
The filter affects signals from both Mic XLR and Line jack socket.
MONO INPUT CHANNEL