Crate Amplifiers GTX65 - Manual (Page 9)

9
Using the Footswitch for More Presets:
The Crate three-button footswitch supplied with the GTX65 allows access to an addi-
tional DSP preset for each channel of the amplifier. When the footswitch is connected to
the amplifier as shown below, the “original” DSP presets are active for each channel
when the #3 footswitch LED is illuminated. These are referred to as “DSP Bank ‘A’.”
When the #3 button is switched and the LED is out, a second DSP preset may be stored
and recalled for each channel - “DSP Bank ‘B’.”
NOTE: DSP Bank “B” presets are only accessible when the footswitch is connected to the amplifier. When
the footswitch is not connected, only DSP Bank “A” is accessable.
CHANNEL
FOOTSWITCH
EXTENSION
SPEAKER
INSERT DSP
CLEAN
SOLO/RTHM
BANK A
BANK B
CAUTION: TO REDUCE THE RISK O F F I R E ,
R E P L AC E F U S E W I T H SAME TYPE AND RATING.
ATTENTION: UTILISER UN FUSI B L E D E
R E C H A N G E D E M E M E TYPE.
100VAC: T2.5A 250V
120VAC: T2A 250V
230/240VAC: T1.25A 250V
"LEFT" jack "RIGHT" jack
Switch #1:
LED on = SOLO CH.
LED off = RHTYHM CH.
Only when Switch #2
is activated (LED lit)!
Switch #2:
LED on = SOLO/
RHYTHM CH.
LED off = CLEAN
CH.
Switch #3:
LED on = DSP
BANK "A"
LED off = DSP
BANK "B"
3 2 1
CHANNEL
FOOTSWITCH
DSP
CLEAN
SOLO/RTHM
BANK A
BANK B
CHANNEL
FOOTSWITCH
DSP
CLEAN
SOLO/RTHM
BANK A
BANK B
GTX65
Three-Channel Guitar Amplifier with Advanced DSP