Clarion RX755VD - Manual (Page 26)

28
VRX755VD
English
Owner
’s
manual
Basic Operations
Adjusting the GENERAL
Setting the BEEP
∗ The sound heard when you make operations is
called “ beep ”. The unit can be set up so that it
does not produce this beep sound.
∗ The factory default setting is “ BEEP ON ”.
1. When the panel is open, press the [ ADJ ]
button to select the ADJUST mode menu.
2. Touch the [ GENERAL ] key.
Touch the [ BEEP ] key to select “ ON ” and
“ OFF ”.
3. Touch the [ RTN ] key, [ ESC ] key, or press the
[ ADJ ] button.
Setting the button illumination
∗ The factory default setting is “ GREEN ” (green).
1. When the panel is open, press the [ ADJ ]
button to select the ADJUST mode menu.
2. Touch the [ GENERAL ] key.
3. Touch the [ KEY ILLUMI ] key to select “ RED ”
(red) or “ GREEN ” (green).
4. Touch the [ RTN ] key, [ ESC ] key, or press the
[ ADJ ] button.
Clock Adjustment
1. When the panel is open, press the [ ADJ ]
button to select the ADJUST mode menu.
2. Touch the [ GENERAL ] key.
Touch the [ CLOCK ] key to adjust the time.
3. Touch the [ w], [z], [ a.m ] or [ p.m ] key to
adjust the time, then touch the [ SET ] key.
∗ The time is displayed in 12-hour format.
4. Touch the [ RTN ] key, [ ESC ] key, or press the
[ ADJ ] button.
Setting the Auto Panel
When you remove or attach the DCP, you can
set the liquid crystal panel automatically housing
or opening.
∗ The factory default setting is “ ON ”.
1. Press the [ ADJ ] button to select the ADJUST
mode menu.
2. Touch the [ GENERAL ] key.
Touch the [ AUTO PANEL ] key to set “ ON ”,
“ OFF ” or “ CLOSE ”.
ON : The liquid crystal panel houses
automatically after removing the
DCP.
And the liquid crystal panel open
automatically after attaching the
DCP.
OFF : Normal operation.
CLOSE : The liquid crystal panel houses
automatically after removing the
DCP.
3. Touch the [ RTN ] key, [ ESC ] key, or press the
[ ADJ ] button.
Switching CONNECT(connect)
Make the following settings when an external
device is connected to the Visual terminal.
NAVI: when a navigation system is
connected
∗ When a navigation system is
connected, use the monitor lock
function. Locking the monitor locks
the screen size in F.WIDE mode (full
wide) and the VTR system to NTSC.
OTHERS: for external devices other than a
navigation system
NONE: when no external devices are
connected
∗ The factory default setting is “ NONE ”.
1. When the panel is open, press the [ ADJ ]
button to display the ADJUST mode menu.
2. Touch the [ GENERAL ] key.
Touch the [ CONNECT ] key to select “ NAVI ”
or “ OTHERS ” or “ NONE ”.
3. Touch the [ RTN ] key, [ ESC ] key, or press the
[ ADJ ] button.
Time setting in air conditioner
operation mode
This setting can be used to adjust the time the
panel stays in the horizontal position when in
the air conditioner operation mode.
* The factory default setting is “ 10s ”.
1. Press the [ ADJ ] button.
2. Touch the [ GENERAL ] key.
3. Touch the [ HVAC MODE ] key to set to “ 5s, ”
“ 10s, ” or “ 30s. ”
4. Touch the [ RTN ] key, [ ESC ] key, or press the
[ ADJ ] button.