Cisco TOPSPIN SFS 3001 - Manual (Page 18)

10
5. Plug InfiniBand Cables from the host to the InfiniBand switch.
a. To plug in an InfiniBand cable, push the connector into the interface until you hear/feel a click.
Figure 1-7: Fully Installed IB Cable with Pinch Connector
NOTE: If your host does not provide an ample amount of free space around a given IB port,
double-check that your IB cable connector engages fully. Wiggle your connector back and forth to be
sure that both sides of the connector have locked firmly into place.
b. To remove a cable with a pinch connector, pinch both sides of the back of the connector and
pull the connector away from the port.
Figure 1-8: Removing a Pinch Connector
Install the Element Manager (GUI)
1. Check that you have sufficient system resources. You will need the following:
• 32 MB free RAM
• 50 MB disk space + 50MB additional temporary space during installation