Cisco TOPSPIN SFS 3001 User Manual
Page 17
9
d. Open a terminal or graphic window and access the top-level directory on the CD-ROM
e.
Execute the command ./tsinstall in a terminal window. This program automatically detects the
available kernel and installs the appropriate drivers as RPM packages. By default, topspin files
are saved in the /usr/local/topspin directory.
4. Configure the HCA drivers.
a.
Configure the IPoIB driver by assigning an IP address to interface ib0 and/or ib1, which
corresponds to the two HCA ports. IPoIB drivers load when the interfaces are used for the first
time.
To assign ib interfaces, enter ifconfig ib# ip-address netmask netmask:
Example of One HCA
Example of Two HCAs
a.
(Optional) Configure MPI.
•
Make sure that your connections to the HCA uses port 1 of the first HCA. MPI requires
the use of HCA 1, port 1.
•
Setup rsh or ssh on two nodes so that you can run commands between a remote and local
node without entering a login or password. This is required to use the MPI protocol.
•
Add paths to your environment PATH:
/usr/local/topspin/mpi/mpich/bin
/usr/local/topspin/bin
or
•
Add the paths for all users by adding the following line to your /etc/profile.d script:
export PATH=$PATH:/usr/local/topspin/mpi/mpich/bin:/usr/local/topspin/bin
b. Configure all other drivers, including SDP.
Refer to the Host Channel Adapter Installation Guide for instructions.
# cdmount ./tsinstall
# ifconfig ib0 192.168.0.0 netmask 255.255.255.0
#
# ifconfig ib1 192.168.0.1 netmask 255.255.255.0
#
# ifconfig ib0 192.168.0.0 netmask 255.255.255.0
#
# ifconfig ib1 192.168.0.1 netmask 255.255.255.0
#
# ifconfig ib2 192.168.0.2 netmask 255.255.255.0
#
# ifconfig ib3 192.168.0.3 netmask 255.255.255.0
#