beautypg.com

Installation & testing – Zippy ARD-6400F User Manual

Page 32

background image


1.6. INSTALLATION & TESTING

Turn off (remote off) the on / off switch

.

Mount the power supply in the system chassis using the proper mounting hardware, the

mounting

holes in the power supply should match up with those in the case. Attach the connectors to the

motherboard by following the motherboard’s instructions, there are various on

connectors/pinouts

in both the power supply and motherboard. They should match each other; otherwise the

connection will cause undetectable harms.

Attach all the remaining power supply connections to the various peripherals as needed,

these connectors are “keyed”, so there will be only one possible way to connect them.

Before applying power to the system, make sure there are no loose or incorrect connections.

The input voltage has been set to the correct voltage (110/220 VAC, the voltage selector locate

at DC fan side), double check that all connection to the motherboard are properly matched.

May be you would like to test the redundancy function before you put back the cover of your

system chassis. Turn on / remote on the on/off switch, you will notice that if the power unit is

operating properly, then individual LEDs, external warning LEDs (Please refer to Sec. 1.9 for

detail explanation) are lit GREEN, now remove one of the power modules, the Warning Buzzer

in the power system will sound, and the external warning LED which display the status of the

total power supply system will change color to be RED, the individual LEDs (both on the rear

side or on the front control panel) indicating the power supply’s status will not light. Meanwhile

the power supply will continue to backup the power output without affecting the computer

system’s operation.

The Warning Buzzer will continue sounding, the user can reset the Warning Buzzer by

pressing the buzzer reset switch at the rear side, refer to the drawing on Sec. 1.3, or use the

reset switch which can be found on the front control panel of the system chassis, the reset

switch can be connected by wires lead provided from the power supply system (Please refer to

Sec. 1.9).

Insert the power module which is removed for testing earlier, the sound of the Warning Buzzer

will disappear, the external warning LED will turn GREEN again. The LED indicating the status

of the power supply will light again, test another power supply by performing the similar

procedure.

If you use the power defective signal, there are two pins connector (refer to the drawing on Sec

1.3 and table on Sec. 1.9), it should be connected to the FAB-5 card properly, please refer its

User’s Manual.