Input characteristics: psl-6701p, Output characteristics – Zippy PSL-6701P User Manual
Page 11
–
–
HG2, HP2, PSM and PSL
Ver. 1.0
11
14
INPUT CHARACTERISTICS:
PSL-6701P
VOLTAGE: 90 ~ 264 VAC FULL RANGE.
FREQUENCY: 47 ~ 63 Hz.
INPUT CURRENT: 10.0 / 11.0 / 12 A FOR 115 VAC, 5.0 / 5.5 / 6.0 A FOR 230 VAC.
INRUSH CURRENT: 65 A MAX. FOR 115 VAC, 125 A MAX. FOR 230 VAC.
OUTPUT CHARACTERISTICS:
OUTPUT CURRENT
REGULATION
OUTPUT
MIN.[A] MAX.[A]
LOAD
LINE
5V
2.5
35
±
4%
±
1%
60mV
12V
1.0
45
±
5%
±
1%
100mV
-5V
0
0.8
±
5%
±
1%
100mV
-12V
0
1.0
±
5%
±
1%
100mV
3.3V
1.0
30
+5, -5%
±
1%
60mV
+5VSB
0.1
2
±
5%
±
1%
60mV
OUTPUT
VOLTAGE
RIPPLE & NOISE
MAX. [P-P]
REMARK:
TOTAL OUTPUT POWER SHOULD NOT EXCEED
700W
for PSL-6701P.
*** WHEN PERFORMING CROSS REGULATION TEST, IT IS REQUESTED TO SET THE HIGHER OUTPUT
CHANNEL AT 90% MAXIMUM AND THE LOWER OUTPUT CHANNELS AT 20% MININUM OF RATED
SPEC.
TEMPERATURE RANGE: OPERATING 0
0
C --- 40
0
C, STORAGE –20
0
C --- 70
0
C.
HUMIDITY: 10 ~ 90 % RH.
HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & 90 VAC INPUT VOLTAGE.
DIELECTRIC WITHSTAND:
INPUT / OUTPUT 1500 VAC FOR 1 MINUTE,
INPUT TO FRAME GROUND 1500 VAC FOR 1 MINUTE.
EFFICIENCY: 70% TYPICAL, AT FULL LOAD.
POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms.
OVER LOAD PROTECTION: 110 ~ 160% MAX.
OVER VOLTAGE PROTECTION:
+5V
5.7V ~ 6.5V, 3.3V
3.9 ~ 4.3V, 12V
13.6 ~ 15V.
EMI: MEET FCC CLASS B, CISPR22 CLASS B.
SAFETY: MEET UL 1950, CSA 22.2 NO/ 950, TÜV IEC 950.
REMOTE ON / OFF CONTROL.
SHORT CIRCUIT PROTECTION: SHUTDOWN AND LATCH.
REMOTE SENSING ON 3.3 V DESIGN.
MEET IEC-1000-3-2 CLASS D (ACTIVE PFC).
DIMENSION: 86(H) X 150(W) X 220 (D) mm (STRETCH PS/2).
COOLING: ONE 80 mm DC BALL BEARING FAN.
I
2
C FEATURES (OPTIONAL).