Workrite Sierra HX Spacer - Manual (Page 2)

B B
B B
2 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Workrite Product - Assembly Instructions for specific product variation
Attach Leg Assemblies with Support Angles to table top
Secure 5” Spacer to table top. 3” Spacers do not attach to table top.
3
4
2
a
a
a Follow the two leg table instructions for both end legs. Center leg does not require spacers. Each
HX Support Angle is attached to only one end leg spacer.
Attaching Spacer & Support Angle For Three Leg Tables:
Refer back to the Table Assembly Instructions to attach Leg Assemblies to the table top with the
HX Support Angles.
Attach the 5” Spacer to the table top
after attaching the leg assemblies to
the table top.
For two leg tables, this is after
instructions 1500165 step 5 .
For three leg tables, this is after
instructions 1500166 step 6 .
For two leg tables, these are instructions
1500165 steps 2 and 3 .
For three leg tables, these are instructions
1500166 steps 2 , 3 and 4 .