Workrite Fundamentals EX Electric Assembly Instructions for 2-leg Workcenters 54”–72” Wide - Manual (Page 5)

6⅛"
6⅛"
2⅞"
2⅞"
Workrite Ergonomics | 800.959.9675 www.workriteergo.com 5 of 8
Workrite Fundamentals Workcenters - Assembly Instructions for 2-leg Tables, 54”–72” Wide
Attach Base to Worksurface and Tighten Screws (continued)
If you do not have a
Workrite worksurface:
Position leg assemblies on
bottom side of worksurface
using measurements a
below.
Mark placement of mounting
holes, then use ⅛" drill bit
to drill pilot holes at marked
locations. You may wish to
mark your drill bit so you
do not drill any more than
¾" deep and damage your
worksurface top.
Do not drill all the way
through worksurface!
4
a
b
b
a
a
c
d
e
Attach loosely using Pan Head Top Screws
(K). If you use an electric screwdriver, be
sure it is on the lowest torque setting to
avoid stripping the holes in the top.
Tighten all screws connecting brackets to
leg assemblies.
Then tighten all screws attaching brackets
to top.
front
3 screws per Short Bracket
5 screws per Long Bracket
4 screws per
End Bracket
K
K
B
C
A
A
E
K
c