Workrite Sonoma Series PREMIUM Assembly Instructions - Manual (Page 4)

1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.workriteergo.com Page 4
1500068 • Rev. C
Sonoma Series
™
PREMIUM Workcenters
1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.wrea.com Page 4
ASSEMBLY INSTRUCTIONS
Slide Crossbar onto Crossbar Brackets and attach
with two machine screws to each bracket.
Attach Top Brackets to underside of the worksurface.
Note: do not fully tighten screws. Screw cable
spools to underside of worksurface. Note that the
attachment locations are marked with labels.
Attach Control Box and Control Panel to the underside of the
worksurface. Mounting holes are provided. Plug leg cables into
control box. NOTE: There are three 6-pin female connectors
on the control box. On a 2-leg table, connect the leg cables
to the middle and furthest to the right connectors from the
power cable. To insure that cables fit tight to the underside of
worksurface, wrap excess cable length around spools as required.
Plug leg cables into plugs extending from
legs. Wrap Control panel cable
around spool as required and plug
into Control Box. Use velcro
straps to take up remaining
slack in cables.
If you are assembling a three leg table, note that
the middle leg is oriented at a 45˚ angle. The side
with the double flange Crossbar Bracket faces the
front edge of the table.
STEP 5
STEP 6 STEP 7
3 LEG
Control Box uses 3/4”
screws for attachment
Control Panel uses #8 x 5/8 ”
screws for attachment